Troubleshooting Tips For Single Bit Error Log File

Over the past few days, some readers have encountered a known error code with a log file indicating a single bit error. Several factors can cause this problem. We will talk about this below.

PC running slow?

1. Download ASR Pro from the website

2. Install it on your computer

3. Run the scan to find any malware or virus that might be lurking in your system

Improve the speed of your computer today by downloading this software - it will fix your PC problems.

Yes. Slot B charge error But slot B will probably run out of memory now. I get the same error, date and time every time I check the memory (express option). It looks like it is scanning the old log file and exiting when it encounters an error message in this situation. I go through all the operating system event logs and usually remove the NVRAM with jumpers because the CMOS battery is removed properly. Same message for logging in, except that I am not getting the platform from you.

You can use the CSTM> Logtool utility to clear the memory log and you can view the PDT by aborting the connection process by entering the service menu (enter ser by entering the MAIN> prompt) and pdt clear write.

This will bring up another and restart, after the system comes back you can start monitoring all memory.
The pdt process frees up low quality memory. It’s best not to take it off unless you need to replace it.

With the Logtool utility, you can track recoverable errors detected by your computer, for example р:

To start the Logtool utility:
1. Start the logtool utility by typing runutil logtool at the cstm> command line.
2. Enter the required requirements when prompted “Logtool>”

Information is displayed on the screen.
4. If you have problems, see the help section of the troubleshooting tool.
6. Exit Logtool by participating in “Exit” (EX) in “Logtool Prompt Utility>”.

Save (after-sales service). … … Save the main Logtool window
Print (PRN) – Print the main Logtool window
Exit (EX) – Exit Logtool and return to the STM prompt

Memory commands:
ClearLog (CL) – delete signal file from memory
SetTimer (ST) – change request duration for registering memory errors
ViewDealloc (VDA) – display errors related to freed memory errors
ViewDetail (VD): view the entire memory report file

Help Commands
Help (HE) – Display Online Help for Logtool
Version (VERS) – Display Logtool Version and Copyright Information
Interrupt Control-C – Tool.

[All personal opinions expressed are and are not traditional statements made byon behalf of Hewlett Packard Enterprise]

CVMX_L2C_ERR_VBF ERROR: 0x102c000000000000 L2C_TADX_INT ERROR (0) [VBFSBE]: L2 VBF single bit error

• processor cache is ECC protected memory.
• If the data stream occurs with one bit changed (for example 0001011 as incoming 1001011), only one dab error is logged and logged.

CVMX_L2C_ERR_VBF ERROR: 0x102c000000000000 L2C_TADX_INT ERROR (0) [VBFSBE]: VBF single bit error

• If the above errors appear once in the logs and can be ignored, but the event causing them could have been resolved on its own
• However, there is a possibility that it will recur. Contact GTAC. to contact the Extreme Networks Global Technical Support Center (GTAC).

Did this article help you solve your problem?Yes No

Comments

Want to read Slashdot on someone else’s mobile device? Show it’s at m.slashdot.org and keep reading!