Table of Contents
PC running slow?
In some cases, your system may display an error with the apc smartups 1000 error message. There can be several reasons for this problem to occur.
What are the basic troubleshooting steps for the Back-UPS RS Normal br1000g model?
During operation, the inverter may not operate as expected. This may be due to a malfunction, a configuration problem, and/or the installation environment.
This document will help your organization perform basic troubleshooting.
Problem | Possible Cause | Solution |
Back-UPS changes to | Device not connected to mains.> | Make sure the main unit is securely connected to the electrical outlet. |
circuit breaker tripped. | Disconnect colspan=”1″ critical non-devices from the new device. Reset the circuit breaker. Combine new items separately. If all circuit breakers trip again, it means that the disconnector has caused the device to trip. | |
Extension not connected.Td | ||
The battery AC input voltage is out of range. | Set the transmission voltage and span sensitivity. | |
Device does not power up during power failure. Colspan=”1 ” | Unplug colspan=”1″ devices from the OVERVOLTAGE ONLY outlet and close it, plug it back in to the outlet. BACKUP BATTERY.Colspan=”3″ | |
The device runs on battery power when connected to AC power. | The plug was disconnected at the same time as the mains socket, the mains socket is not normally mains powered, or the entire circuit breaker has tripped. | Check rowspan=” that the plug is properly connected. inserted depending on the wall outlet. Verify that the ceiling outlet is connected to AC power by simply testing it with someone else’s device. |
We are running an automatic self-test. | No action required. Colspan=”1″ required. Colspan=”1″ | |
Program in login software the voltage is out of range, the target frequency is out of range, or the target waveform is distorted. | Adjust the transport voltage sensitivity and range. | |
Device not no prediction ensures fuse duration. | Battery output fuse may be defective or fully charged. | Disconnect the devices from the BATTERY BACKUP sockets and connect the devicesPlugs to outlets, OVERVOLTAGE ONLY. |
Battery colspan=”1″ recently suffered a power outage due to being drained and not fully charged. Colspan=”1″ | ||
life expired. | variety(APCRBC123 ). | < Colspan="1" /td> |
REPLACE turns on a strong battery indicator . | Battery has reached the end of its life. | Replace battery ( APCRBC123). |
< /td> | ||
Turns on the overload indicator. Colspan=”1″ | Equipment associated with an item design has more power than the item can provide. | Disconnect devices due to BACKUP battery from fr outputs and connect them to supported devices es ONLY WAVES. |
The colspan=”1″ SYSTEM FAULT LED is on and all LEDs on the front panel are flashing. | An internal error occurs frequently. | determines that an error message is being displayed from the device by comparing the number displayed on the LCD screen with the corresponding error message (see System Errors), and contact apc technical support. |
System error: |
< |
|
not flowing – some outlets. | Supervised outlets have been powered off on purpose. | Confirm rowspan=”1 that you, the devices, are correctly connected to the outlets being monitored. If you absolutely don’t need this feature, disable the main power saver in combination with controlled outlets. |
Maybe the threshold output of the master device is set incorrectly. Colspan=”1″ | Set the time for which the master output signals the controlled output to be disabled.< /td> | |