Do you know how to fix fatal error 173 in Oki c6100?

1) Turn on the printer by pressing the + and - buttons at the same time; release when OKIUSER is displayed. 2) Press the + or - button when “ENGINE DIAG MODE” is displayed; Press the full Enter key and the screen displays DIAGNOSTIC MODE xx.xx.xx.

Steps to fix Oki B4600 Error 173 - Silicon Valley Gazette

Table of Contents

In the past few days, some of our users reported that they encountered error 173 oki b4600.

PC running slow?

1. Download ASR Pro from the website

2. Install it on your computer

3. Run the scan to find any malware or virus that might be lurking in your system

Improve the speed of your computer today by downloading this software - it will fix your PC problems.

g.Turn off the power, make sure the printer is plugged directly into a wall outlet and not a better surge protector, and remove and reinsert the fuser. If the “173 Thoughts” error persists, the thermocouple must be replaced.

Code: 173
Description: maximum heating temperature, status: Low
Remedy: Switch the device and turn it on again. • Yes Is the thermistor open or short-circuited? Measure the human resistance between thermistor pins (heat sink touches 120V / 2Î © or 240V / 7Î © and 200KÎ © thermistor pins to room temperature). • Yes Replace the fuser. • No Is the thermistor plug connected to the best connector on the voltage / sensor board? “Do not connect a thermistor with this connection property. • Yes Is the fusing unit air conditioner turned on (when the heater is turned on, nodoubt that light is being emitted)? â € œ Yes Check thermistor connections or replace main control board and fuser. • No Is there AC voltage at the outlet to heat the electric stove? • None Replace the main gearbox board or power supply board. • Yes Check the heating connection cable and heating connection for poor contact with.

Onclick = “Window