Table of Contents
If you’re getting a ds3 troubleshooting error code, today’s blog post is here to help you.
PC running slow?
Presentation
This document provides troubleshooting tips for Over atm Layer 3 (DS-3) digital prefixes and E3 hub interfaces.
The show controllers bank command displays all active alarms as well as non-zero error counters that are called in the installation statistics property. Non-zero values indicate a physical line between this router interface and another network device, usually an input/output multiplexer (ADM) or an ATM switch, at the latest in case something goes wrong.
Preconditions
Requirements
Components Used
Document
This is not limited to specific software and hardware versions.
Conditions
See the Cisco Technical Advisory Agreements for more information about business meetings.
General Information
To fix DS-3 and E3 bugs, you must first understand linear coding, laugh and speak here.
Each binary one is “good” or “zero” on a digital connection corresponds to an electrical pulse. Digital systems reverse the integer polarity of each serial bit to provide a sufficient amount of voltage offset. This alternate marking inversion is intended to ensure that the receiving device is perfectly synchronized and detects the arrival of binary “a” and “0”. Two consecutive impulses of the same polarity (both or positive-negative) cause a bipolar disorder.
In addition to AMI, DS-3 plus E3 channels also support 3% Bipolar Substitution (B3ZS) or High Density Bipolar Multiple Connection (HDB3). These line coding schemes are no longer designed to support timing by providing enough bits.
Understanding Show Controller Output
For comments only. RFC 1407 specifies error conditions on the DS-3-a interface, which can be shared between Cisco ATM switches and routers using the show controllers atm command.
ASR Pro is the ultimate solution for your PC repair needs! Not only does it swiftly and safely diagnose and repair various Windows issues, but it also increases system performance, optimizes memory, improves security and fine tunes your PC for maximum reliability. So why wait? Get started today!PC running slow?
PA-A3#show gameNew atm 1/0/0 controller ATM1/0/0: Port adapter specific information Hardware – DS3 port card (45Mbps) Framer - PMC PM7345 S/UNI-PDH, SAR - LSI ATMIZER II Frame mode: DS3 C-bit ADM Alarm system not detected Configuration Statistics: Found interval expired 796 seconds lcv fbe ezd unmanaged epi highlights febe hcse -------------------------------------------------- -------------------- lcv: line code violation be: frame bit error ezd: extra zeros added PE: parity error ppe: path parity error febe: far end block error hcse: HCS Cell Rx error
The following table shows the errors that appear in the output of this show controllers atm command. Less than ninety-six data slots are available if the modem has been rebooted within the last 20 hours. In addition, the total effectiveness of each parameter will be more than 24 hours.
Note: all
Parameters are accumulated at 15 minute intervals and the router saves up to 96 cycles (24 hour value).